Order service now
address zhengzhou , china

welcome to visit us

Contact Us

[email protected]

High and New Industrial Zone, Kexue Revenue, High and New Technology Industrial Development Zone, Zhengzhou, China

Get in Touch

If you have any problems about our product and service,please feel free to give your inquiry in the form below. We will reply you within 24 hours as soon as possible.Thank you!

project reports on slag sand Products

project reports on slag sand - wembleyprimaryschool.co.za. Project Reports On Slag Sand . Project Reports On Slag Sand 11properties and effects of copper slag in concrete 46 properties and effects of copper slag in concrete matil applied mechanics department s national institute of technology surat gujarat abstract copper slag is a by product obtained during matte smelting and refining of ...

MD 16 SHA UM 2 30 Steel Slag Report

Dec 04, 2014 Dec 04, 2014 STEEL SLAG USE IN HIGHWAY CONSTRUCTION Ahmet H. Aydilek UNIVERSITY OF MARYLAND, COLLEGE PARK Project number SP209B4H FINAL REPORT October, 2015 MD-16-SHA-UM-2-30. ii The contents of this report reflect the views of the authors who are responsible for the

Experimental Study on Concrete by Replacing Fine Aggregate

May 29, 2020 May 29, 2020 This project reports on an experimental program to investigate the effect of Using copper slag as a replacement of sand on the properties of concrete .Six concrete mixtures were prepared with different proportions of copper slag of Weight basis (0 percent (for the control mix), 15,25 and 30 percentage.

Copper slag as sand replacement for high performance

Abstract. This paper reports on an experimental program to investigate the effect of using copper slag as a replacement of sand on the properties of high performance concrete (HPC). Eight concrete mixtures were prepared with different proportions of copper slag ranging from 0% (for the control mix) to 100%.

Project Report On Copper Slag In Concrete

Today I’m going to be shared about “Project Report on Copper Slag in Concrete” With advantages and disadvantages of copper slag in concrete so let’s get started. Introduction Traditionally soil, stone aggregates, sand, bitumen, cement etc. are used for road construction.

Sand For Concrete From Steel Mills Induction Furnace Waste

Slag sand – The sample used in the study as obtained from local steel mills, no crushing, sieving are any other process/treatment done in it. Its physical composition given in Tables 2. The grading of slag sand found to be of Zone-II as per IS: 383-1970. 4. Aggregate – 20 mm graded crushed aggregate from local crushes was used in this study ...

Alternative Sand An Inevitable Resource to River Sand

Research on natural crushed rock sand, copper slag, waste foundry sand, coal ash, recycle sand etc. has shown that these can also be used in concrete as fine aggregate [7, 8], either in full or as fractional replacement of natural sand [8-10].

Ground Granulated Blast Furnace Slag Conclusion

Ground Granulated Blast furnace Slag consist essentially silicates and alumino silicates of calcium. Portland cement is a good catalyst for activation of slag because it contains the three main chemical components that activate slag: lime, calcium sulphate and alkalies. The material has glassy structure and is ground to less than 45 microns.

PDF INFLUENCE OF FLY ASH ON STRENGTH OF CONCRETE

FINAL YEAR PROJECT REPORT Page 14 Table 1: Physical Properties and Particle size distribution of ISF slag Physical properties of ISF slag Sr. No. Physical property Test Value 1 Specific Gravity 3.62 2 Water Absorption 0.35% Particle size distribution of ISF slag Sr. No. Sieve Size % Passing Cumulative % Retained 1 10mm 100 0 2 4.75 mm 99.6 0.40 ...

A REVIEW OF INNOVATIVE USE OF COPPER SLAG AND FOUNDRY SAND

For M 20 and M 25 grade concrete, the optimum sand replacement proportion is generally 35- 40%. Moreover, generally the sand can be replaced till 50-60% by copper slag in concrete. 4. The ...

CIVIL ENGINEERING PROJECTS projects with reports and

Copper slag is the one of the industrial waste available. It is a by product of copper production from copper core. During smelting, a molten pool of copper forms at the bottom of the furnace while a layer of impure metal, which is the slag, is drained off from the top. Copper slag and lime form cementateous material on hydration.

PDF Characterization Report on Sand Slag and Crucible

This paper reports on the chemical characterization of the sand, slag, and crucible (SS and C) residues and the fluoride residues that may be shipped from the Rocky Flats Environmental Technology Site (RFETS) to Savannah River Site (SRS).

Utilization of Copper Slag in M Sand as Partial

By our Project, we conclude that strength of concrete increased by the replacement of M-sand by copper slag, saves concrete material cost. Here we are using OPC of 53 grade, Well graded coarse and fine aggregate. 30% copper slag replacement showed Maximum workability. The workability of concrete …

Hot news

Click avatar to contact us
Click avatar to contact us
gotop